Instructions for use and maintenance of electric pump/tank pump

Because the electric pump is running at high speed, the grease is extremely volatile, so it needs to be lubricated and kept clean.
Instructions for use and maintenance of electric pump/tank pump

1. Because of the high speed operation, the electric pump is extremely volatile, so it needs to be lubricated and kept clean.

2. The electric pump should be inspected regularly, repaired, and the power cord should be checked for wiring, plugs, and switches. The insulation resistance is normal, the tailstock of the brush is loose, the contact with the commutator is good, and the armature is enlarged. Whether there is a moderate disconnection in the winding stage of the stator winding, damage to the bearing and moving parts, etc.

3. Keep the same parts and replacement parts. The disintegration of the pump should save every part of it. Pay special attention to the part of the explosion-proof surface so that the damage can not be brushed including the insulating gasket and casing. If the damage is to be replaced, the same The parts shall not be lower than the parts that use alternative materials or that do not conform to the original specifications. All parts that are installed in the original position shall be assembled and shall not be missed.

4, long-term use of electric pump or leave the pump in wet conditions, the winding must be measured with a 500 volt megohmmeter before use. As the insulation resistance between the winding and the motor housing less than 7 megohms, The winding must be dried.

5. The electric pump should be stored in a dry, clean, non-corrosive atmosphere.

Article from: http://?438.html
China Hardware Business Network http://news.chinawj.com.cn Editor: (Hardware Business Network Information Center) http://news.chinawj.com.cn